Experimental study of a broad-band XeCl double-pass amplifier with SBS mirror

An oscillator-amplifier XeCl laser system has been used to experimentally investigate the effectiveness of a liquid stimulated Brillouin scattering (SBS) mirror for correcting the spatial aberrations of broad-band laser radiation in a double-pass amplifier. It has been found that the SBS amplifier performance is strongly dependent on the intensity I _p exciting the Brillouin medium. A good beam reconstruction has been attained at I _p1GW/cm², whereas highly aberrated output beams have been delivered by the SBS amplifier for I _p>1 GW/cm². By comparing the broad-band SBS amplifier performance to that of the same amplifier with a dielectrically coated flat mirror at one end, it has been found that the use of a SBS mirror is advantageous to obtain lower divergence output beams only for low energy pump beams (<1 mJ).     

Reaction of ketenes with N,N-disubstituted α-aminomethyleneketones VIII. Synthesis of N,N-disubstituted 4-amino-3-chloro-6-phenyl-2H-pyran-2-ones

The dipolar 1,4-cycloaddition of dichloroketene to N,N-disubstituted 3-amino-1-phenyl-2-propene-1-onesled directly to N,N-disubstituted 4-amino-3-chloro-6-phenyl-2H-pyran-2-ones only in the case of an usual aliphatic N,N-disubstitution. In the case of partial or full aromatic N-substitution, N,N-disubstituted 4-amino-3,3-dichloro-3,4-dihydro-6-phenyl-2H-pyran-2-ones were instead obtained, which were dehydrochlorinated with DBN to the corresponding 4-amino-3-chloro-6-phenyl-2H-pyran-2-ones.     

Partitioning of metals between the aqueous phase and suspended insoluble material in fog droplets

This paper discusses the partitioning of metals (K, Na, Ca, Mg, Al, Cu, Fe, Pb and Zn) between the aqueous phase and the suspended insoluble material in fog samples collected in the Po Valley during two extensive fields campaigns. Metals represent on average 11% of the mass of suspended insoluble matter, while the main component is carbon (both organic carbon, OC = 35%, and black carbon, BC = 8%). The unaccounted suspended matter mass is very high, on average 46%, and is attributable to non metallic species, such as O and N and of Si. The principal metals in the insoluble suspended fraction are Fe and Al (2-5%), while the contributions of other metals (Na, Mg, Cu, Pb and Zn) are lower than 1%. Ca and K exhibited high blank values and could not be detected above blank detection limit threshold. The main components in the aqueous phase are NO3- (34%), WSOC (23%), SO4(2-) (18%) and NH4+ (19%), while trace metals and remaining cations and anions accounted for less than 1% of solute mass. The main dissolved trace metals in fog droplets are Zn, Al and Fe, while the main metallic cations are Na and Ca. Fe and Al are the only metals preferentially distributed in the suspended insoluble matter of fog droplets (partitioning ratio respectively 37% and 33%). All other metals are mostly dissolved in the aqueous phase (mean partitioning ratios of Mg, Pb, Zn, Cu and Na are 69%, 70%, 77%, 81% and 87%). These findings are in agreement with literature data on metal speciation in cloud and rain samples. The dependence of partitioning ratios on pH is investigated for the different metals, with only Al showing a clear partitioning ratio decrease with increasing pH. Conversely, the other metals show no dependence or a complex and highly variable behaviour. The partitioning ratio of iron (mean 37%) observed in the Po Valley fog samples is much higher than the water extractable iron in aerosol particles (typically 1-2 %): this fact can be explained by differences in the aerosol sources and composition among sites and by chemical processes in the aqueous phase, such as complexation and redox reactions involving organic ligands (oxalate, or other organic acids as humic-like organic matter) which may promote Fe solubility.     

A Ten Years Monitoring of Chlorofluorocarbons at the Antarctica: Results and Perspectives

Abstract

Chlorofluorocarbons are man-made long lasting atmospheric pollutants of great environmental concern, responsible for important global change phenomena. Recently, they were replaced by hydrogenated halocarbons that, even if less persistent, do not lack in environmental impact. Atmospheric concentrations of these compounds were measured in Antarctica by gas chromatography. The extremely low atmospheric mixing ratios of these compounds require a pre-concentration step of the air sample on suitable adsorbent in order to meet the sensitivity of the analytical method Results obtained analyzing air samples collected in Antarctica since 1988 for the determination of CFC-12 and CFC-11 are reported, together with data concerning the less abundant species.     

Wide Oscillation Finite Time Blow Up for Solutions to Nonlinear Fourth Order Differential Equations

We give sufficient conditions for local solutions to some fourth order semilinear ordinary differential equations to blow up in finite time with wide oscillations, a phenomenon not visible for lower order equations. The result is then applied to several classes of semilinear partial differential equations in order to characterize the blow up of solutions including, in particular, its applications to a suspension bridge model. We also give numerical results which describe this oscillating blow up and allow us to suggest several open problems and to formulate some related conjectures.     

Optimal Transportation with an Oscillation-Type Cost: The One-Dimensional Case

The main result of this paper is the existence of an optimal transport map T between two given measures μ and ν, for a cost which considers the maximal oscillation of T at scale δ, given by ω _δ (T) :?=??sup_|x???y|?<?δ |T(x)???T(y)|. The minimization of this criterion finds applications in the field of privacy-respectful data transmission. The existence proof unfortunately only works in dimension one and is based on some monotonicity considerations.     

Electrolytic Oxidation of Thiocyanate and Selenocyanate Salts and the Photoelectrochemical Effect.

New photosensitive materials can be obtained by electrochemical oxidation of thiocyanate and selenocyanate salts. Using (K,Na)SCN eutectic melt, the formation of an electrodic deposit, with photoelectrochemical properties, has already been reported by us. To improve the photoelectrochemical characteristics of the deposit, futher investigations were carried out in the following sistems: selenocyanate ammoniate, KSCH-Acetamide eutectic mixture and KSCN ethylene carbonate solution:. Attempts to obtain a massive deposit in the ammoniate solution were unsuccessful due to ammonia oxidation. Measurements performed on the other KSCN systems show that temperature is a parameter of remarkable importance. In fact, lowering the temperature one obtains a decrease on formation of parathiocyanogen on behalf of the polytrithiocyanogen, the species that gives rise to the photoeffect.     

Effective medium representation and complex modes in 3D periodic metamaterials made of cubic resonators with large permittivity at mid-infrared frequencies

We review some of the techniques that lead to the effective medium representation of a three-dimensional (3D) periodic metamaterial. We consider a 3D lattice of lead telluride cubic resonators at mid-infrared (MIR) frequencies. Each cubic resonator is modeled with both an electric and a magnetic dipole, through a method called the dual dipole approximation. The electric and magnetic polarizabilities of a cubic resonator are computed via full-wave simulations by mapping the resonator's scattered field under electric/magnetic excitation only to the field radiated by an equivalent electric/magnetic dipole. We then analyze the allowed modes in the lattice, with transverse polarization and complex wavenumber, highlighting the attenuation that each mode experiences after one free space wavelength. We observe the presence of two modes with low attenuation constant, dominant in different frequency ranges, able to propagate inside the lattice: this allows the treatment of the metamaterial as a homogeneous material with effective parameters, evaluated by using various techniques. We then show that the metamaterial under analysis allows for the generation of artificial magnetism (i.e., relative effective permeability different than unity, including negative permeability with low losses) at MIR frequencies.